Green team:

• Stabilize the red/green difference using a slow feedback path.
• Hand-off to red.
• Noise measurement between red and green locked on red.
• Make a mode scan of the red resonances.
• ETM drive diagonalization for length and angle..
• ITM drive diagonalization for angle.
• Centroid fit for ITMX camera..

Red team:

• Commissioning of the initial dither alignment system.
• Fix: BS feedback triggering an ISI trip.
• Center the red QPDs in EX.
• Investigate the robustness of the 3f lock in presence of an arm cavity
• Start commissioning the alignment system.
• REFL_A calibration.
• Optimize the thermal compensation of ITMY.
• Investigate the REFLAIR45 whitening filter issue.
• PRC length measurement.

Blue team (ALS WFS):

• Stability investigation.
• Re-measure sensing matrix.
• Beam quality investigation.
• Diagonalization of dither alignment feedback.

Blue team (ISCTEY, delayed):

• Prepare second set of WFS Complete the feedthrough panels.
• Install the on table cabling.
• Prepare for move to the end station.
• Check out ALS electronics in EY.
• Add WFS.

TMS:

• Ground loop investigation.
• Beam alignment in final position.

SEI/SUS team:

• Install optical lever damping for vertical and roll modes.
• Improve stability under high performance for ETMX.
• Fix: TwinCAT reboot trps HAM ISI.