This morning the end Y laser was off and had no power, Richard looked around and noticed that there was an extension chord which had come loose.  He changed the way that this is plugged in so this should not happen again.

Alexa and I placed the GigE camera on ISCT1 for the X arm.  

I also went out to End Y a few times to work on the IR path there.  The LSC PD is now aligned for the IR trans, the gain setting is 60dB.  The power cable is flaky for the analog camera.  Aaron and Fil helped get the signal to the control room. Although the spot is faint you can see it in the upper right hand corner of channel A on the lower monitor.