I installed the RTD temperature sensors on HAM 4 and 5. The existing HAM 4 RTD that was broken, Alog 11942, was replaced with a new RTD (D1102257-01 V1 SN# S1201366). HAM 5 had a functional RTD hooked up to the cable mount thanks to SUS, so the install went quickly enough. All of the sensor ends seemed to survive, but confirmation will have to wait until at least tomorrow when an impedance test can be done.

The particle counts were good going into chamber.
HAM 4 clean room: 0
HAM 4 chamber: 0

HAM 5 clean room: 0
HAM 5 chamber: 0