Matlab TFs are set to run at the X end station overnight as follows:- - ETMX (QUAD) M0-M0 undamped TFs - ETMX (QUAD) R0-R0 undamped TFs - ETMX (QUAD) L1-L1 undamped TFs - ETMX (QUAD) L2-L2 undamped TFs Starting now, and when complete the measurement status will revert to OFF and damping loops will be restored to the ON state. Also, note that I have transitioned the BSC-ISI ST1 from DAMPED to HIGH_ISOLATED via Guardian, thus enabling ST1 isolation for this measurement. These measurements have been initiated from the opsws2 workstation.