After consulting with Keita and TMS group, we finalized where we wanted the QPD cables to go [we have to be EXTREMELY careful with cabling the QPDs because if the wrong cable is connected to these guys we run the risk of frying the QPDs---several QPDs were damaged during the H2 TMS Installation]. Basically, we stuck with what the drawing (D1300007) calls out. But I made sure to clearly label the external flanges to where the QPDs are connected (see photo).
Below is the latest cable run-thru with Flanges noted:
In-Air Cable |
Chamber feed-thru |
In-vac cable | Cable Bracket | In-Vac Cable |
Cable Bracket on TMS |
In-Vac Component |
---|---|---|---|---|---|---|
H1:SUS_BSC9_TMONX-1("SUS1") | .....|E6-7C1|..... | D1000225 s/n S1106816 | CB3, 1st floor | D1000234 s/n V2-96-903 | --- | OSEMS: Face1, Face2, Face3, Left |
H1:SUS_BSC9_TMONX-4("SUS2") | .....|E6-7C2|..... | D1000225 s/n S1106771 | CB3, 2nd floor | D1000234 s/n V2-88-934 | --- | OSEMS: Right, Side, ---, --- |
: In-Air cable not run yet : | .....|E4-2C1|..... | D1000924 s/n S1104104 | CB6, 1st floor | D1000568 s/n S1104110 | CB-primary, 1st floor | Green QPD (D1000231 s/nS1202413) |
: In-Air cable not run yet : | .....|E4-1C2|..... | D1000924 s/n S1203963 | CB6, 2nd floor | D1000568 s/n S1202739 | CB-primary, 2nd floor | Red QPD (D1000231 s/nS1202411) |
: In-Air cable not run yet : | .....|E4-1C1|..... | D1000223 s/n S1202653 | CB5, 1st floor | D1000921 s/n S1104112* | CB-entry, 2nd floor | Picomotors (D1000238 s/n S1105218) |
: In-Air cable not run yet : | .....|E4-2C2|..... | D1000223 s/n S1202656 | CB5, 2nd floor | D1000921 s/n S1104113 | CB-entry, 1st floor | Beam Diverter (D1000237 s/n S1202724) |
in-vac cable | cable bracket | in-vac cable | in-vac component |
H1:SUS_BSC9_TMONX-1("SUS1") |
in-vac cable | cable bracket | in-vac cable | in-vac component |
H1:SUS_BSC9_TMONX-1("SUS1") |
ICS Note: D1000225 s/n S1106771 is not in ICS :-/