[Stuart A, Jeff K, Jeff B] In preparation for the QUAD model updates that were recently made at LLO (see LLO aLOG entry 15323), I've today svn'd up the common model parts directory, as follows:- /opt/rtcds/userapps/trunk/sus/common/models/ U QUAD_MASTER.mdl A ESD_LINEARIZATION_WITH_CHARGE_MASTER.mdl A ESD_LINEARIZATION_WITH_CHARGE_OUTF.mdl A FOUROSEM_DAMPED_STAGE_MASTER_WITH_DAMP_MODE.mdl U HLTS_MASTER.mdl U SIXOSEM_F_STAGE_MASTER.md U BSFM_MASTER.mdl U FOUROSEM_STAGE_MASTER_OPLEV.mdl U MC_MASTER.mdl U HSSS_MASTER.mdl U HSTS_MASTER.mdl U FOUROSEM_STAGE_MASTER.mdl n.b. only the first four above model parts are necessary for the QUAD updates, however, the remaining updates include grounded unused inputs required for when updating to RCG 2.9. Checking out the following c-code was also necessary for the ESD remote reset functionality:- /opt/rtcds/userapps/release/cds/common/src A LONG_PULSE.c I then updated the local top-level wiring for all the H1 QUADs to accommodate the updated QUAD_MASTER.mdl, these will be checked in once they are rebuilt and restarted in the morning:- /opt/rtcds/userapps/release/sus/h1/models/ ? h1susetmx.mdl ? h1susetmy.mdl ? h1susitmx.mdl ? h1susitmy.mdl I test built the above models on thw h1build machine and encountered no issues for the ITMs. However, the ETMs failed to build due to missing IPC senders in the h1lsc model (H1:LSC-ETMY_DARM_ERR & H1:LSC-ETMY_DARM_ERR), which will be rectified in the morning. Screen-shots of the updated local QUAD models are attached below. All looks good to proceed with the LSC/QUAD model rebuild, install and restarts tomorrow.