I repeated the measurement from alog 15783, just checking coherence between HAMs 2&3 after we changed HAM3 to look at the right seismometer. Nothing obvious, but I found something interesting. The FIR_IN signals should all be the exactly same at this point, and so should be 100% coherent, between the chambers. The Z signal is not, but the difference is only below 50 mhz, at around .6hz the coherence is almost 100% again. Attached plot shows measurement from the middle of last ni.
Sensor correction is off on HAMs 2&3, I will leave it off on these chambers overnight. I'm also switching the cables on the AA chassis at the rack for STS-A. Will swap back tomorrow morning.