LVEA: Laser Hazard Observation Bit: Commissioning 08:00 Jodi & Rodica – In LVEA looking for IO parts 08:13 Manny – Removing test stand cables from LVEA west bay 08:30 Jodi – Out of LVEA 09:00 Jodi – In LVEA working with Rodica on IO 09:12 Hugh – In LVEA working on 3IFO HAM storage retrofits 09:18 Elli – Working on IOT2R table 09:20 Mitch – Going to LVEA for HAM 3IFO storage work 09:25 Filiberto – Going into LVEA to help Manny with removing cables from the west bay 09:29 Jodi – Out of the LVEA 10:30 Kyle – At End-X to start vent 10:31 Peter & Rick – Going to End-Y to work on PCal camera focus 10:31 Hugh & Mitch – Out of the LVEA 10:34 Travis – Going into the cleaning area to get tools for End-X vent 11:24 Doug – Checking TCS chiller alarm 11:49 Filiberto – Out of LVEA 11:49 Filiberto – Going to End-Y and End-X to check on TCS equipment 12:00 Electrical inspector on site to inspect work at VPW 12:00 Manny – Out of the LVEA 12:05 Doug – Out of the LVEA 12:08 Jodi & Rodica – Out of the LVEA 12:35 Jodi & Rodica – Going to Mid-Y to check on 3IFO IO parts 13:17 Filiberto – Back from end stations 13:20 Jodi & Rodica – Back from Mid-Y 13:36 Sudarshan – Working on PCal cameras at End-Y 13:45 Kyle & Gerardo – At End-X working on BSC9 vent 14:05 Corey – Going to squeezer bay 14:40 Kyle & Gerardo – Back from End-X 14:56 Dale – Taking tour into LVEA 14:57 Bubba & Kyle – Going to End-X to remove BSC9 door 14:57 Travis & Betsy – Gathering tools and heading to End-X for EQ stop work 15:17 Elli – Going to IOTC2R to check on fan noise 15:35 Corey – Out of the squeezer bay 15:43 Betsy – Going to End-X for Quad EQ stop work