After the ISC crew were finished, Jim unlocked the ISI and made a small adjustment to it's balance. I wiped a few of the surfaces of the ISI and chamber that I could reach near the door. I placed a witness plate on the ISI table in the middle of the sea of ISC mirrors nearest the east side of the table. Kyle, Gerardo, Bubba and I then tacked the door on with 4 bolts. Kyle turned off the purge air. Dan/Keita and Jim are running OM/OMC and ISI TFs to see how we fair for pumping down tomorrow. We're not yet out of the woods. TBC...
PS Particle counts at the door interface while the door was going back on was
0.3um 10
0.5um 10
1.0um 0
Here's a picture of the HAM6 table as viewed from the end (East) door. The new CC wafer is now inbetween the sea of mirrors/BDs/TTs.