Summarized H1 issues from last Fri/Sat & how we did over the weekend: Combination of environment & ALS glitching possible culprit for issues Fri/Sat. However we've been locked since about noon on Sat (going on 45hrs).
RF45 appears stable (will prob hold off on swapping cable until/if issue comes back & NOT address during Maintenance. Only address if needed).
Also discussion of "Freeze". Sounds like we are still in a partial freeze.
There was discussion about allowing Beam Tube repairs (will be discussed offline).
Commissioning & Any Invasive Activities:
-
All activities need to be covered by a Work Permit during O1!
-
Single IFO data is still used for pulsar investigations!
Regular Tues Maintance Activities
There are activities which occur every week and these do not require a Work Permit, but need to be done on a recurring basis. A short list of these (also on whiteboard) is:
-
ETM charge Measurement
-
PSL WD Button
-
"REAL" LVEA Sweep
-
3rd IFO Storage monitor & maintenance
-
HEPI fluid levels monitor
-
N2 Delivery
-
A2L Decouple Measurement
10/6 Tues Maintenance Activities
Ed is Operator on shift (& TJ is available as a secondary operator, if needed)
-
EX annulus ion pump swap, 3-4hrs, start early (Gerardo/Kyle)
-
HEPI pressure sensor swap (Hugh)
-
Reset power watchdog on PSL (will do every week and not need work permit) (Jason)
-
Forklift LSB to Mechanical & check humidity sensors for dry cabinets (bartlett)
-
More DMT channels to EPICS (hanks)
-
SDF slow control/beckhoff test, requires DAQ restart (hanks)
-
8-9 no internet (ryan)
-
rolling racks pulled out of lvea & 3IFO checks (jodi)
-
angle to length decoupling measurement (sheila)
-
OMC change during lock acquisition (Sheila)
-
Lockloss tracking (Sheila)
-
-200m work for VAC (Richard)
-
PEM injection set up (Robert)
-
EY glitch investigations (Robert)
-
ETM Charge measurements (Betsy)
-
Two nitrogen loads
-
LVEA Sweep, still in a holding pattern, but will address minimal-affecting items