I checked out the hardware/software we need for implementing POP_X:
-
The WFS sensor head is available and "stored" on ISCT6
needs to be moved to ISCT1 with some additional optics and a PZT steering mirror
-
The WFS power supply is the one for REFLAIR_A (3rd channel of WFS interface chassis in R4)
-
The DC signals are hooked-up to the DAQ and readout in the ASC model
-
The entire demod chain (original REFL leapfrog) is available, powered up and read by the DAQ
-
The in-rack RF cable for the 36MHz demod is being made
-
The WFS cables will be taken from a REFL WFS (REFL_B 45 seems to reach/R2)
-
We need to mount an MCL controller on top of ISCT1, requires power
-
The feedthrough panel is on order as well as the required DB9 cables
-
The cables between the MCL controller and the DE2SE converter in R1 are being made
-
The h1asc model was updated to send the pit and yaw signals to the DAC channels
(these channels were removed from the h1imcasc model, where they were hooked up, but not used)
The models have been build, but not installed
-
Some medm screens need to be updated
Documents: