After Richard, Fil and Patrick got the new PT170 and TP180 Beckhoff gauges being read out by ECATC1PLC1, I elected to add these channels to the H0EDCU_VE.ini DAQ file after we encoutered problems getting the full ecat ini file transfered to the userapps area. The additional lines are shown below.

Hugh and I had performed a "make install-h1isiitmy" earlier in the afternoon, so this DAQ restart required us to restart the H1ISIITMY model. We confirmed with Hugh and made the model restart just prior to the DAQ restart.

The DAQ was restarted at approx 6pm PDT Monday, The TORR channels are trending correctly. I modified the vacuum overview MEDM screen to display the TORR channels.

This morning we copied the new h1ecatc1plc1 autoBurt.req file into the ecat target.

[H1:VAC-LX_X2_PT170_PRESS_VALID]
[H1:VAC-LX_X2_PT170_PRESS_OVERRANGE]
[H1:VAC-LX_X2_PT170_PRESS_UNDERRANGE]
[H1:VAC-LX_X2_PT170_PRESS_TORR]
[H1:VAC-LX_X2_PT170_PRESS_SENSOR]
[H1:VAC-LX_X2_PT170_PRESS_TRIP]
[H1:VAC-LY_Y2_PT180_PRESS_VALID]
[H1:VAC-LY_Y2_PT180_PRESS_OVERRANGE]
[H1:VAC-LY_Y2_PT180_PRESS_UNDERRANGE]
[H1:VAC-LY_Y2_PT180_PRESS_TORR]
[H1:VAC-LY_Y2_PT180_PRESS_SENSOR]
[H1:VAC-LY_Y2_PT180_PRESS_TRIP]