corey.gray@LIGO.ORG - posted 16:04, Monday 11 April 2016 - last comment - 16:17, Monday 11 April 2016(26517)
DAY Ops Summary
Day's Activities:
- 8:15: Karen checking out HAM6 area
- 8:49: Running cables for Access System between HAM1-4; most of the day. (Fil & Ed)
- 8:50: BSC (ETMx) new Controller work ["so can run on CPS only"] (Jim)
- 9:41: BRS EX code work beginning; most of the day (Krishna & Michael)
- 9:53: PSL crew doing measurements from outside in the morning and then working in the enclosure in the afternoon.
- 9:58: EX to check water tank (John)
- 9:58: EX Beckhoff stopped running last Thurs (Batch notified us & Patrick investigating). Operator note: One can tell if Beckhoff goes down by looking at the Slow Controls section on the CDS Overview....if anything is frozen, it's not running.
- 10:08-10:19: HAM6 AS90 offset jumps investigation (Jenne)
- 10:26: EY ESD measurements (Fil & Evan)
- 10:40: HAM6 pump down; confirmed picomotor controller is DISABLED (via sitemap/LSC/picomotor/HAM6 ISCT6) (Kyle, Chandra)
- 10:42: Possible cleanroom work (Jeff)
- 10:51: EX seismometer holes (Robert, Manny)
- 11:10: Getting HAM7 & 12 Annulus Ion Pumps back online (Gerardo)
- 11:30: ITMy STS2 pulled out to be put in a hole at EX (Jim W., Robert)
- 1:08: Entering PSL Enclosure to continue work (Peter, Jason)
- 1:52: Climbing around BSC4 Annulus Ion Pump (Kyle)
- 2:09: EX PEM cabling (Fil)
- 2:38: Cimbing on HAM12 pulling signal cable (Kyle)
- 3:07: HAM6 Vacuum gauge work (Richard)
- 3:20: Opening Gate Valves! (Kyle, Chandra)
- 3:35: MY CP3 work (Kyle)
- 4:03: Craning pump cart over X-Beam Manifold to expedite pumping down of HAM6 (Kyle)
"Operator note: One can tell if Beckhoff goes down by looking at the Slow Controls section on the CDS Overview....if anything is frozen, it's not running."
As a reminder, the DIAG_MAIN has a test to look for exactly that. Though, it has become saturated and lit up from all of the vent and PSL work going on.