(Corey, Fil, Richard M, Sheila)

Per Fil's Work Permit #6071 (Fil took care of running/connecting the camera's shielded network cable to the table's Patch Panel earlier):

• Went inside ISCT1 to remove the POP analog camera (see drawing photo & D1201103) + the internal cables for it.  I did NOT remove the external cable.  The external cable was left connected on the outside of the Analog Video Patch Panel #3 Connector, (see photo) and this could be removed any time.
• Installed (coarsely) a new GigE Camera + internal network cable.  This camera still should have its alignment checked, but this requires a locked H1.  This camera is connected on the GigE Camera Patch Panel #2 on connector #1.  (see photo)
  • Richard fired up the camera and said it looks good.  
  • This camera will need to be added and/or labeled on the H1VID_DIGITAL_OVERVIEW.adl
  • Action Item:  Update drawing D1201103 (when I have time and also learn how to use omnigraffle).
• Side Note:  Richard replaced the #1 & #2 network cables (connected to GigE Camera Patch Panel#1) with new shielded cables.

Work Permit #6071 can now be CLOSED.