15:30 Morning meeting. Minute in aLog
15:50 Bubba into LVEA to finish eyewash station inspections
16:05 Kyle into LVEA
16:15 Fil into LVEA to do HVAC relay interlock work the BSC7 and HAM6 area
16:16 Jason into PSL
16:45 Dave will be restarting the FSS model to add a couple of channels. DAQ restart may NOT be necessary as staed in the WP. WP#6100
16:47 FIl and Mark out to BSC3 and PSL racks to terminate some DB9s and HV relay interlock work.
17:11 Jason out temporarily
17:21 FSS model restart complete.
17:30 Jason and Peter into enclosure for restarting th LASER
17:31 Fil to EX for FRS - missing ISC cables
17:32 Richard to EX, also, to replcae a temp module. WP#6101
17:38 Dust monitor 10 500NMYellow alarm.
17:49 Dust monitor 10 500NM YELLOW alarm and 300NM RED Alarm
18:00 Dust monitor 10 500NM RED alarm.
18:01 Chandra out to valve in ION pump at HAM6. WP#6103
18:04 Gerardo out to pull cable from Y vacuum rack to points at the H2 input/output
18:11 Dust monitor 10 500NM YELLOW alarm.
18:22 Dust monitor 10 500NM RED alarm.
18:36 Fil and Richard back from EX
18:43 18:11 Dust monitor 6 300NM RED alarm.
18:55 Dust monitor 6 300NM YELLOW alarm.
18:58 CJ into the optics lab
19:03 Gerardo out for lunch
19:35 Jason and Peter out for lunch. FE LASER is on. Shutter is closed. Warm up period before locking FSS/PMC etc.
17:31 Fil to EY for FRS - missing ISC cables
20:19 Kyle into LVEA
20:39 Jason out to LVEA to reset noise eater.
20:41 Mark back out to the LVEA. Terminating cables at the ISC racks next to PSL.
20:56 Mark out
21:02 Jason out to the PSL enclosure
21:50 Kyle into LVEA
21:52 Kyle out
22:16 Jason out of the enclosure
22:20 LASER is back and we are taking steps to recover and start initial alignment