This was an "Initial Sweep", in that a couple of incursions (PSL ISS work by Kiwamu & part search by Betsy) occurred after this Sweep, but they will make sure LVEA is in a Swept state when they are done.

Used the LVEA Sweep checklist (here on DCC & Wiki).  Items worth noting:

LVEA Phone Locations:

Not clear where & how many phones we have to look for when sweeping.  These are phones I came across:

1. East Bay along north wall near HAM6
2. Squeezer Bay table 
3. South Bay (on west wall near H1PSL & on red tool box)
4. North Bay (on west wall near H2 PSL & on red tool box)
5. In CER in SW corner of room in the back

Crane Prarking:

East Bay crane was a few feet away from "Parking Spot".

BSC8 Scroll Pump Running

There is a Pump running at BSC8.  Kyle has talked to Keita and Patrick (ops on shift) about this.  May disconnect at end of the day.  Although Kyle mentioned this pump not seen as a noise source when H1 was running.

LVEA CDS Wifi??
I did not check to see if this was turned OFF.  Will not turn OFF in case Kyle needs wifi for his laptop.

H1PSL Room & H2PSL Room Science Mode Transition

This wasn't technically checked off last week.  So I went out and went through the PSL Science Mode checksheet, T1400648 (laminated copy of this checksheet is at the H1 PSL [not H2]).  An overview for taking PSLs to Science mode is here, T1500459.  There is also a PSL Science Mode wiki page, here; on this page there is mention of making sure DBB electronics are OFF (they are).

H1PSL was taken to Science Mode by me.  Kiwamu will be going inside & will take it to Science Mode again.

H2PSL had a few variances:

• The Make Up Air was ON.  I turned if OFF.  (hope that was OK, Jason.)
• There is a light ON inside the air shower & there are no light switches outside the enclosure to shut them off.