(corey, greg, jim)
HAM7ISI Springs have been installed, pulled-down, and Spring Safety hardware is in place. Did a first run through on the Optics Table to pull out any broken/loose tangs. The Optics Table can be installed tomorrow. At this point, I was able to note quite a few serial numbers (s/n) while they were easily viewable. Here are some of them:
Springs
(where the Tip is associated with each Corner; i.e. a Spring which is bolted down to a Spring Post of Corner-3 actually has its Tip in the Corner-1 area)
Spring Posts
Flexures
Stage0: 014
Stage1: 010
Optics Table: 009
More Serial Numbers:
Actuators (installed 6/27)
CPS Probes (as slotted in satelite boxes)