TITLE: 01/31 Day Shift: 16:00-00:00 UTC (08:00-16:00 PST), all times posted in UTC
STATE of H1: Preventitive Maintenance
INCOMING OPERATOR: Jim
SHIFT SUMMARY:
Maintenance Day roughly stopped around 23:00utc (3pm); not tons of activities, but we allowed some work to take us past our noontime "deadline". Thank you to Patrick, TJ, & Travis helping me out with work I had to pawn off on them.
Immediately upon looking at ALS locking, BOTH arms looked atrocious. Took a while to finally get away from zero and to a point where the alignment looked serviceable (Jim suggested I probably look at temperatures because of this...or it could be due to all the BSCISIs going down). At any rate, in the last hour of the shift, I rushed to try and have an aligned H1 to hand off to Jim.
OK, handing an aligned H1 to Jim.
LOG:
Lost unsaved draft, so times are iffy below:
-
1st Norco truck arrives before 16:00
-
before 1600 wp6460 beckhoff access (richard)
-
before 1600 wp6431 beckhoff update for Ion Pumps (patrick)
-
16:15 - 17:10 EX/EY cleaning
-
16:16 EX PCal Calibration (travis)
-
16:20 HAM1 dustmonitor slight move (Jeff)
-
16:26OMC Dither & control loop tests attempted while H1 was locked (Keita)
-
16:31 H1 dropped lock
-
16:31-21:00 RF measurements in CER (dick)
-
16:50 EY STS Centering (Hugh, TJ)
-
17:00 GRB Alarm (SNEWS pipeline)
-
17:01 TCSy safety interlock work, swapping back electronics since still had glitches(fil)
-
17:09 Yuki, Heather, Rick heading out to EX
-
17:18 Battery check (Joe)
-
HAM6 IP maintenance (gerardo)
-
TCSy interlock work (fil)
-
2nd Norco truck left at 11:30
-
EY Humidifier work (bubba/john)
-
MX purge air maint (gerardo)
-
EY illuminator work (fil)
-
CP4 maint (chandra, kyle)
-
ISI model change (hugh)
-
Temperature sensor survey (bubba/john)
-
ITM scatter measurements (betsy/jason)
-
Hit RELOAD on ISC_LOCK per alog 33735
-
EY search for hardware (John/Bubba)
-
21:45 Charge Measurements (TJ)
-
22:05-22:25 LVEA sweep
-
23:08-23:15 power cycle on beckhoff Access System (Fil)
-
23:16 GRB, not locked.
-
23:11 Started Initial Alignment