State of H1: IFO unlocked after maintenance window. Started initial alignment    

Intent Bit: Commissioning/Locking

Support: N/A

Incoming Operator: Travis

 

Shift Summary: Down for entire shift for maintenance. After work in the PSL finished started and initial alignment. Travis will finish the initial alignment.   

 

Activity Log: Time - UTC (PT)

16:00 (08:00) Take over from TJ

16:19 (08:19) Richard – Going to End-X to work on Beckhoff Safe System

16:20 (08:20) Peter – Going into PSL to retrieve cables

16:21 (08:21) Chris – Escorting pest control in LVEA

16:24 (08:24) Lockloss – Maintenance window

16:28 (08:28) Bubba – Going to CS roof to check equipment

16:31 (08:31) Joe – In LVEA to service batteries

16:33 (08:33) Karen – Cleaning at End-Y

16:33 (08:33) Chris – Finished in LVEA

16:33 (08:33) Chris – Escorting pest control along the Y-Arm  

16:34 (08:34) Peter – Out of the PSL

16:41 (08:41) Cintas on site to service mats

16:42 (08:42) Hugh & Jim – Going to End-Y to center BRS (WP #6469)

17:00 (09:00) Bubba to escort water delivery to both end stations

17:02 (09:02) Kyle – Going into the LVEA to check equipment on elevated slabs

17:03 (09:03) Chris – Finished on Y-Arm

17:03 (09:03) Chris – Escorting pest control along X-Arm

17:10 (09:10) Richard – Back from End-Y

17:15 (09:15) Cheryl – Going into the PSL (WP #6468)

17:16 (09:16) Filiberto – Going into CER to label cables – May also go into LVEA

17:21 (09:21) Kyle – Out of the LVEA

17:25 (09:25) Betsy – Going into west bay to work on 3IFO stuff

17:28 (09:28) Chandra – Going into the LVEA to inspect vacuum equipment

17:34 (09:34) Kyle – Going into the VEAs at both end stations

17:52 (09:52) Apollo on site to see Bubba

17:53 (09:53) Jason – Going into the PSL

17:55 (09:55) Karen – Leaving End-Y

17:56 (09:56) Christina – Leaving End-X

18:01 (10:01) Richard – Going into LVEA to do some cabling

18:02 (10:02) Bubba – Back from both Ends

18:05 (10:05) Bubba – Escorting Apollo in LVEA to inspect HVAC

18:12 (10:12) Joe – Out of the LVEA

18:16 (10:16) Richard – Finished in the LVEA

18:17 (10:17) Richard – Going to End-X to install cable

18:23 (10:23) Norco – N2 delivery to CP2

18:30 (10:30) Jason – Out of the PSL Enclosure

18:37 (10:37) Cheryl – Out of the PSL

18:39 (10:39) Richard – Out of the LVEA

19:01 (11:01) Richard – Going to HAM6 to check wiring

19:12 (11:12) Richard – Out of the LVEA

19:27 (11:27) Kyle – Back from the end stations

19:28 (11:28) Kyle – Going into the LVEA for vacuum equipment checks

19:30 (11:30) Bubba & Apollo – Out of the LVEA

19:35 (11:35) Joe – Out of the LVEA

19:47 (11:47) Betsy – Out of the LVEA

21:00 (13:00) Cheryl & Sheila – In the PSL to fix a clipping problem

22:15 (14:15) Hugh & Jim – Back from End-Y – BRS is still a problem

22:30 (14:30) Cheryl out of the PSL - Kiwamu in the PSL

23:30 (15:30) Shelia & Kiwamu – Out of the PSL

23:30 (15:30) Sheila – Finished the LVEA sweep that I had started earlier

23:35 (15:35) Start initial alignment

00:00 (16:00) Turn over to Travis