WP6477 Check IRIG-B connections at end stations
Jim, Dave, Daniel:
We went to EY and verified that the IRIG-B signal which is recorded by h1iscex FEC is sent from the IRIG-B fanout. Because it goes into a 10xGain AA chassis, it has a voltage divider installed. Daniel confirmed that this signal should be sent from the CNS-II GPS receiver. In fact I had included this modification in the timing drawings during O1 and was presumably waiting end of O1 to change. We will work on getting this resolved installed ASAP. We did not make it to EY, it should be identical to EX.
WP6478 WAPS power up sends notification to sysadmin
Carlos, Richard:
LVEA and EY CDS WAPs were energized, no notification was received. This is a work-in-progress, will keep this WP open.
WP6475 TCS FLIR camera power control
Richard, Peter:
Verified that the switch inside the TCS enclosure toggles between REMOTE and ON. When in the REMOTE position, the Beckhoff system can turn the camera on and off. Both ITMX and ITMY cameras are in the REMOTE state, and Beckhoff has them turned OFF. We ran out of time to take an image, will start doing this weekly, beginning next Tuesday.
WP6479 DMT GSTLAL upgrade
Greg:
gstlal code was updated on the GDS machines
WP6480 GDS code update
Greg, John Z:
GDS code was updated on all GDS machines
WP6457 remove coil driver BIO from WD, HAM3
Hugh, Dave:
new h1isiham3 code was installed. Now only ham2 is running with the coil driver input to the watchdog.
WP6473 OAF add matrix, fix divide-by-zero
Sheila, Dave:
new h1oaf model was loaded
WP6483 Split corner station HWS server into two for ITMX, ITMY readout
Carlos, Dave:
h1hwsmsr had two camera cards. One is now in the new machine called h1hwsmsr1. While this work is on-going, H1EDCU_HWS.ini was removed from the DAQ to keep the EDCU green.
SDF safe vs OBSERVE reference investigation
Dave:
Not all FECs are in the OBSERVE reference. I noticed that it is not easy to trend which file is being used at any time in the past (e.g. when in observation mode). I have written a python script to add the SDF channels to the FEC autoBurt.req so the hourly autoburt will record this information. Plus conlog will then also monitor these channels for a true trend.
h1guardian0 reboot
TJ, Dave:
h1guardian0 was rebooted. It came back up with no problems. I took the opportunity to apply a safe-upgrade patch.
WP6485 Bullseye QPD install
Sheila, Jenne, Richard, Daniel, Dave:
As part of this WP, the h1ecatc1plc2 code was changed to control the spare whitening chassis. A new INI file was generated and added to the DAQ. A new autoBurt.req file was generated and added to the target.
DAQ
Dave:
DAQ configuration was changed to add back the H1EDCU_CONLOG.ini file and temporarily remove the H1EDCU_HWS.ini file. We had two restarts of the DAQ:
12:18PST to support isiham3 and oaf model changes
14:30PST to support Beckhoff changes