WP6457 Removal of coil driver binary in ISI watchdog, h1isiham2 restarted
Hugh, Jim W, Dave:
h1isiham2 was restarted with new code.
WP6505 ASC code upgrade
Jenne, Kiwamu, Keita, Sheila, Dave
h1asc model was modified and restarted. In the DAQ: 1050 slow channels were added, 150 slow channels were remove, 4 fast channels (2048Hz) were added (list below):
+: fast channel H1:PSL-DIAG_BULLSEYE_PIT_OUT_DQ added to the DAQ
+: fast channel H1:PSL-DIAG_BULLSEYE_SUM_OUT_DQ added to the DAQ
+: fast channel H1:PSL-DIAG_BULLSEYE_WID_OUT_DQ added to the DAQ
+: fast channel H1:PSL-DIAG_BULLSEYE_YAW_OUT_DQ added to the DAQ
WP6502 Add RACCESS slow channels to DAQ and autoburt
Dave:
A new H1EDCU_RACCESS.ini file as added to the DAQ dataconcentrator master file. Also a new target h1raccess was created along with its autoBurt.req file for hourly snapshots of remote users.
DAQ Restart:
Dave:
DAQ was restarted to incorporate the above changes to models and EDCU.
WP6507 GDS software upgrade
Jim:
GDS software upgraded to version 2.17.9-2
Guardian DIAG_MAIN restart
Travis, Dave:
The DIAG_MAIN guardian node was stopped and started to free up the memory it was using. The available memory on h1guardian0 went from 35.5GB to 43.7 as a result.
CDS computer labeling
Dave:
In both the EX and EY CDS computer racks all computers are labeled both front and back.
WAP power up notification
Richard, Carlos:
WAP power up notifications were tested. System needs some more investigation. WAPS are now all OFF.
WP6508 h1lsc model change, REFLDC being sent to ASC, should be POPDC.
Jenne, Keita, Dave:
h1lsc mode was modified and restarted. No DAQ restart was necessary.
h1brsex found to have RED error LED on front panel, machine was rebooted and code restarted
Jim, Dave, Carlos:
During my EX visit I noticed that the front panel red led was ON. This had been seen on h1brsey late 2016. h1brsex was rebooted and the code restarted.