Assembly/In-vacuum cabling - Hugh, Jim, Greg, Hugo
ready

• Actuators and sensors connected in vacuum
• In-field cables connected to the feedthroughs
• ADE boxes of the CPSs grounded
• Rough balancing performed
• Locked/Unlocked shift checked (about 0.8v, worse case, on horizontal CPSs)
• Cables (SEI, ISC) dressed to avoid rubbing while taking transfer Functions
  
   

• Sensors and actuators were inverted on the input of the Anti-Alias chassis - corrected
• ADC/DAC organization in the IO chassis was unclear - clarified by testing
• IOP model issues causing a wrong routing of the ADC/DAC signals - corrected
• HAM3-ISI model installed
• HAM3-ISI model updated:
  • ADC to Master model connections modified to match with the in-field cabling.
  • Unused DAC block removed.
• Watchdogs are tripped due to the Coil Driver Chassis BIO. Impossible to reset the watchdogs, and then actuate on the ISI.
  • Coildrivers are ON.
  • Overheat lights are off.
  • The overheat alarm reset-button  was pushed.
  • Coil drivers are connected to the BIO chassis. 
• All testing scripts, but the ones that involve driving were successfully tested
• Matriced loaded in MEDM.