Reports until 16:50, Tuesday 29 June 2010
X1 SEI
david.barker@LIGO.ORG - posted 16:50, Tuesday 29 June 2010 - last comment - 16:50, Tuesday 29 June 2010(37)
rebooted front end 
DB and CG.

killed g1hamisi and g1x01, then rebooted the frontend computer
to clean up its memory [boot performed at 13:50]

DAQD would not run because it needed awgtpman present, so changed daqdrc
to allow running with no awgtpman (otherwise just kept spawning).

Started g1x01 and g1isiham, burt restores worked ok.

Mem usage at this time is (free -m):

[controls@seiteststand ~]$ free -m
             total       used       free     shared    buffers     cached
Mem:          7986       2406       5579          0         82       1062
-/+ buffers/cache:       1262       6724
Swap:         1983          0       1983




Also copied the epics bin area from CDS to the /opt/apps/epics binary directory, but
StripTool does not work.
Comments related to this report
corey.gray@LIGO.ORG - 15:22, Tuesday 29 June 2010 (38)
Link 

After the reboot noted above, Fabrice and I started a fresh Matlab from the iMac at the SEI Test Stand.  After this, I checked the memory usage, and had the following:
[controls@seiteststand ~]$ free -m
             total       used       free     shared    buffers     cached
Mem:          7986       4303       3682          0         97       2615
-/+ buffers/cache:       1590       6395
Swap:         1983          0       1983

So here, matlab has been running for ~10 min.  I ran this command immediately after opening and the "free memory" was 4400 and then 4000.  It seems to be leveling out at 3400 as we are now running a measurement in matlab.