TJ, Jim

This morning TJ and I got parts together and installed the first set of "beard-cover" baffles on the HAM5 ISI. These hang off the +Y side of HAM5, below the beamline and off the table so we think they will be out of the way. We also pulled the old table top baffles and left them in the staging CR next to the chamber. Install for these seemed pretty straight forward. We centered up the middle baffle on the table, using the ISI wall counter bores for guidance. We then installed the outer baffles as far out as we could while still overlapping the center baffle, as seen from HAM4. We put the center baffle as far out from the side of the table as the slots in the mounting brackets would allow and put the side baffles as close to the table as they would go. I would like to get a picture from in the beam tube, but the attached images were the best I could get for now.