chandra.romel@LIGO.ORG - posted 18:33, Wednesday 21 February 2018 - last comment - 10:02, Thursday 22 February 2018(40654)
Progress on CP4 bake enclosure
Framing is erected and most of the insulation pads are up. Need to work out some bugs in the electrical. Reworked a few areas of strut interference. Designer will create as-built drawings. Thanks everyone for your help today: Ken, Mark, Richard. Tomorrow we resume.
Images attached to this report
Comments related to this report
We have an adapter cable to swap CP4's pressure reading from PT-245B to the {temporary} full range hot cathode gauge installed on turbo inlet, since we'll lose PT-245B (electronics) in the heat. Patrick T. is working on software code for this swap. Thanks!
Images attached to this comment
