Status

• Corner Vent pressure good--HAM6 VOPO work should be good to go.
• Can transition to Laser SAFE (Bartlett)
• Discussing HAM6 fiber feedthru flange (Gerardo needs to receive paperwork)
• PSL work continues

LVEA:  VOPO Install (Corey, TJ, Alvaro with Bubba observing).  And then fine tuning rest of the week.  Might need beam/laser HAZARD Wed. 

EX:  Vented, IP12 removal (Tues), door off (wed/later?), Arm install (later in week)

EY:  PCal work beginning of the week, ground loop checks, elec field measurements later in week, Vacuum install tasks next week

MY:  CP4 Bakeout start this week sometime

Tues Maint: 

• ISI model boots,
• framewriter work,
  SQZ model update,
• DAQ boot,
• Beckhoff SDF (hanks),
• Redundant trend writers (hanks),
• Tues Operator be on look out for any issues which could affect alignment from these bootfests...want to be ready for HAM6 alignment later this week. 
• Corner station HEPI maintenance, 

Safety: 

• IR only glasses use at EY for PCal.  This is a waived and rare occasion.  Rick & Peter talked about it. (Mike L)
• Want to be good with housekeeping! (Bubb)
• Do not leave in-air optical table doors open if you are leaving table unattended--even if we are Laser HAZARD. (Peter)