We put ITMY in stops for the BSC2 cartridge install.

  We had a small issue with the bump stops between the CP and Test mass touching. We could not engage the face stops enough to hold the Teflon strips in place without the inside bump stops coming together. This occurred even when the barrel stops were in so tight the fluorel cap distorted. Therefore, we put Teflon transport caps on the CP face stops to cover the fluorel & fused silica tips. We put the Teflon strips, freed up from the CP face stops, between the bottom and both side bump stops between the CP and Test Masses. This will prevent glass to silica contact between the two masses during transport.