I've laid out most of the components on IOT1 table including partially setting up the periscopes. The components for the MC REFL path are in roughly the correct position. The components for the MC TRANS path will need to be adjusted for the final periscope location. I looked into using the round periscope that is currently sitting in the MC REFL path and determined that it may be necessary to make some modifications to the design in order to adapt it for use with 2" optics. I've set up the triangular MC TRANS periscope for use with the new 2"optics. 
I cleaned everything that was installed on the table and left the HEPI fan running.

The table currently requires the following items.

1) 4" Holes cut in end panels for venting
2) 45 degree mounts purchased for lower periscope mirrors to mount to table
3) Adaptation of round periscope for 2" optics?