This HAM1 WFS Sled was completed & bagged/stored back in Oct/Nov by Keita.  I opened it up to document a few items (optical component distance, photos, & parts used).  After noting everything I needed, the Sled was wrapped back up & stored in its plastic bin under the Optics Table in the Optics Lab.  It will stay here until installation.  Keita will submit an a document about this Sled to the DCC separately.

Optical Component Distances

For measurements below, the lenses are measured on the "backface" of their Lens Holder.  The Mirrors & Beam Splitters are measured on their glass "front faces".  All measurements in mm.

• Edge of upstream side of Sled (bread board) to L1 = 148mm
• L1 to L2 =  198
• L2 to SM1 = 135
• SM1 to SM2 = 47
• SM2 to BS =48
• BS to SM3 = 368

Photographs

An overall photo of this Sled layout is attached to this entry.  All photos of this Sled are located in ResourceSpace, here.

List Of Components Installed

• (2) D1002059 ISC Mounting Base-Double
• (4) D1002060 ISC Mounting Base-Single
• (1) D1001116  ISC Mounting Post 1-5/8"
• (4) D1000968 ISC Mounting Post 2-1/8"
• (2) 1" Left-Handed Siskiyou Mirror Mounts
• (2) 1" Left-Handed Siskiyou Mirror Mounts w/ Pico Motors
• (1) D1102166 ISC 2" Fixed Optic Holder & Peek Retaing Ring
• (1) FOH-1.00-VC ISC 1" Fixed Optic Holder& Peek Retaing Ring
• (1) E1000845-08  1" f= -166.8mm Lens
• (1) E1000845-10  2" f= +333.6mm Lens
• (1) E1000671-01  1" 50:50 Beam Splitter
• (3) E1000969 1" High Reflector
• (3) D1002701 Mirror Mounted Black Glass Clip w/ black glass
• (3) D1100044 1" Mirror Mount Black Glass
• (1) D1002041 ISC QPD Sled (breadboard)
• Miscellaneous bolts, washers, etc.