After the storm was passing through, ALS x & y were obviously flashing all over the place.  Unfortunately, within a few minutes the green spot for ALSx disappeared (and we had the error:  "ReflPD A; Green input align").

1)  Looking at ETMx, TMSx, & ITMx

Saw shifts for all of these guys, so I returned them to where they were during the lock, but no change for the spot on video.

2) ENDx Overview:  No spot for Green WFS (& offcenter spots for Green QPDs)

3) PDH Locking screen: 

• XALS Laser Green Mon is OK with a power of 1.2mW
• Xarm Green ReflA has an ERROR note & 0mW----When I click this the Error says "Power too low"

Attached is a screenshot of the issue.  Since the power is low I'm wondering if this is still an alignment issue & I just need to sweep optics to get something on the camera.  But I don't really know where to start and where to go.  This is something I can try next.

For the GREEN WFS, I'd prefer to not touch picomotors to get a spot on them, but I'm wondering if ETMX/ITMx/TMSx alignment sweeps could help this?

...........Oh Darn........

As I was going through the Troubleshooting wiki, there is mention of:  If one has symptoms as above (i.e. no power for XARM Green ReflA), one should check the shutters.  I just saw that the ISCTEX green shutter was CLOSED.  I opened it and I atleast now see light (ugly light, but light).  Why would this shutter close on me???

OK, now that I'm not blind, going to try and find the spot for Green X-arm!