Attached are plots of dust counts > .3 microns and > .5 microns in particles per cubic foot from approximately 5 PM Jan. 21 to 5 PM Jan. 22. Also attached are plots of the modes to show when they were running/acquiring data. Dust monitor 10 in the H1 PSL enclosure is still indicating a calibration failure. I did not plot the counts in the labs, since this IOC was rebooted and put 'nan' in the data. The IOC was timing out communicating with the dust monitors, but the Comtrol was still on. Rebooting the IOC seemed to fix it.