(Corey G., Philippe Nguyen, Gavin Wallace)

Continued Magnetic Coil installation at EX from yesterday.  We improved on our technique and got quite a ways done in an hour.  Unfortunately, we had to stop work because we noticed one of the upper corner brackets came undone from the wall (there are a total of 4 screws which are holding these brackets and one of them partially popped out from the wall).  This occurred as we were pulling down on the cable to remove any slack in the loop.  We notified Richard about this and he mentioned that he will get Ken to re-secure this bracket.

As for status of the coil, we counted how many loops we were able to make, and we had about ~75 turns (LVEA one has about 80 turns), so we we were almost done with using the 2nd spool of wire.