WP8520 Adding two fast channels to LSC model

Sheila, Dave:

Sheila made a new h1lsc model which adds two new 16kHz channels to the DAQ:

• H1:LSC-POPAIR_B_RF18_I_ERR_16k_DQ
• H1:LSC-POPAIR_B_RF90_I_ERR_16k_DQ

h1lsc was restarted followed by a DAQ restart

WP8521 Add SUS SW2R channels to DAQ for ramping trends

Dave:

I created a new H1EPICS_SUSSW2R.ini file and added it to the DAQ.

DAQ Restart, Green up EDC

Dave:

DAQ was restarted for three changes:

1. h1lsc fast channels added
2. H1EPICS_SUSWS2R slow channels added
3. H1EPICS_PSLOPC0 slow channels removed while h1pslctrl0 IOC is non-operational

Control Room FOMs

Dave:

I patched the OS on all the control room FoM machines and rebooted them.

Enabled tagging on EX SEI and SUSAUX network ports

Dave:

I enabled ADMINLAN tagging to the H1FELAN ports of h1seiex and h1susauxex to try to get remote IPMI working again for these machines. This was a partial success, I can now ping the IPMI addresses for these machines but ipmi-tool does not connect to them. We may need to power cycle the computers or cold-cycle the IPMI cards to complete this.