Tagging CAL and ISC Groups.

Direct link to ECR and supporting technical note for explanation of changes:
    ECR: E2100204
    Design Study: E2100205

Direct link to DCC file cards for serial numbers:
    EX S1000343
    EY S1102652
Unfortunately, these do not contain raw transfer function data. Will ask Fil if it was saved and if so, if we can get that data posted to these DCC file cards and/or the in to the ^/trunk/Common/Electronics/H1/Data/SUSElectronics corner of the SVN. 

Some historical documentation related to this electronics improvement and/or the PUM drivers:
    LHO:53482 Noise study showing the difference between State 1 and State 3 in terms of use of actuator range.
    LHO:47166 and LHO:47167 The last time we measured the PUM driver's frequency response and updated the compensation in 2019.
    LHO:42662 last time we balanced ETMX's L2 actuator chains.
    LHO:43143 last time we balanced ETMY's L2 actuator chains.

Actions to do well-before O4:
    - need to re-balance coils in State 3 at least, if not all states, and update the https://tinyurl.com/LIGOSUSActuatorTuning Table
    - need to gather new in-situ transfer function data a. la D1900027 if we don't have bench-top testing data (and probably even if we do, since we need all channels, and all states, to such high and low frequencies)
    - fit the data (putting fitting code into new git repo location, https://git.ligo.org/suspensions/ligo/electronics/)
    - Apply updated compensation filters to L2 COILOUTF banks.