J. Kissel

In prep for the restart of sush34 and sush56 this morning and the upgrade of the DACs for the M2 and M3 stages of SRM and SR2, I reconciled the SDFs of the suspensions and seismic systems that will be impacted. Recall, from Austin's handy Front-end Computer to Suspension Map D2100766, one can see that a *LOT* of suspensions will be brought offline today as a result, even though SRM and SR2 are the only ones that actually receive hardware changes:
    - h1sush34
        ham3 isi/hepi (not restarted, but brought to ISI_DAMPED_HEPI_OFFLINE)
            MC2 in HAM3
            PR2 in HAM3
        ham4 isi/hepi (not restarted, but brought to ISI_DAMPED_HEPI_OFFLINE)
            SR2 in HAM4
    - h1sush56 
        ham5 isi/hepi (not restarted, but brought to ISI_DAMPED_HEPI_OFFLINE)
            SR3
            SRM
            OFI
            ZM6
        ham7 isi (no hepi, so ISI manager brought to DAMPED)
            ZM5
            ZM4
        ham6 isi/hepi (not restarted, but brought to ISI_DAMPED_HEPI_OFFLINE)
            OM1
            OM2
            OM3
            OMC

So, as a result, I reconciled the following:
    ham3 isi/hepi - Looks like Jim changed blend filters on Jun 16th from FM8 to FM10. Accepted this in the OBSERVE.snap only.
        -  Accepting Elenna and Evan's work reshuffling HSTS damping loop filters LHO:64194. Also accepted the current alignment sliders.
        - PR2 Accepting Elenna and Evan's work reshuffling HSTS damping loop filters LHO:64194. Also accepted the current alignment sliders.
    ham4 isi (nothing to reconcile)
       - SR2 (nothing to reconcile). Also accepted the current alignment slider values.
    ham5
       - SRM
            - Accept Sheila's work for installing DAC offsets on all the quadrants of M2 and M3 stages, see two screens worth of accepting: the values and ramps and then the actual buttons being on (LHO aLOG 64326)
            - Separately accepting Elenna and Evan's work reshuffling HSTS damping loop filters LHO:64194. 
            - REVERTED the outputs of the M3 DITHER banks being ON -- probably turned on for a test, but have been stagnant since July. Did this for PRM too.
            - Also accepted the current alignment sliders.
       - SR3 (nothing to reconcile). Also accepted the current alignment sliders.
       - OFI Accepted Alignment Slider Values
       - OMC / OM1 / OM2 / OM3 Alignment Slider Acceptance (includes OFI)
    ham7 isi accepting a vertical offset change
       - ZM4 ZM5 
       
    Unaffected models that I accepted the SDF changes anyways:
       ham2 PRMAccepting Elenna and Evan's work reshuffling HSTS damping loop filters LHO:64194. Also accepted the current alignment sliders.

In short, I accepted: 
     - Alignment sliders
     - HSTS damping loop filter reschuffle
     - SRC DAC offsets
     - HAM3 ISI blend filter change
     - HAM7 vertical position offset