jameson.rollins@LIGO.ORG - posted 10:40, Friday 12 May 2023 - last comment - 08:27, Tuesday 29 August 2023(69537)
hardware injection infrastructure cleanup
I went through the hardware injection screens (CAL_INJ_CONTROL2, PCAL_END_EXC) and cleaned them up based on the way that we're now handling hardware injections
- The INJ_TRANS guardian node was decommissioned, so references to that node were removed from the screen
- The old status bits that were controlled by the INJ_TRANS node were also removed
- The STATUS indicator bits were fixed to reflect their proper
- removed some inaccurate/misleading indicators in the PCAL_END_EXC screen
I then did some test injections and confirmed that all the status bits were working as expected. Here's an example of the screen with an active "detchar" injection (as labeled by the H1:CAL-INJ_TINJ_TYPE record):
The H1:CAL-INJ_STATUS bit word (purple indicators) behaved correctly, and reset appropriately when the EXC was stopped.
Images attached to this report
Comments related to this report
I also note that the H1CALINJ_INJ_TRANSIET filter bank was found to have most of it's filters disengaged. TJ previous determined that all the banks should be engaged. I re-engaged all the fitlers and SDF accepted the change.
I've committed the changes to the PCAL_END_EXC.adl screen (removing the HWINJ master switch, and choice switch for which end-station to drive) to the svn under
/opt/rtcds/userapps/release/cal/common/medm/
PCAL_END_EXC.adl
as of userapps svn repo rev 26171.
Same goes for
/opt/rtcds/userapps/release/cal/common/medm/
CAL_INJ_CONTROL2.adl
committed to rev 26173.