Took H1 out of Observing to run Calibration Suite Measurements.
- Took us out of OBSERVING, Observatory Mode to CALIBRATION, & took ISC_LOCK to NLN_CAL_MEAS
- Opened terminal and entered/ran: "pydarm measure --run-headless" at 1516utc.
- Measurement completed at 1700utc.
Attached is a screenshot (#1) of the sitemap > CAL CS > Calibration Monitor screen shortly after starting the measurement.
- Measurement at: /ligo/groups/cal/H1/measurements/PCALY2DARM_BB/PCALY2DARM_BB_20230517T151727Z.xml
'pydarm report' command gave attached report:
- /ligo/groups/cal/H1/reports/20230517T163625Z/H1_calibration_report_20230517T163625Z.pdf (attachment #2)
Since, PEM team was going to immediately take H1, did the following:
- CAL_AWG_LINES "loaded" to clear RED Error state (jeff)
- ISC_LOCK: NLN (which turns CAL_AWG_LINES back on)
- CAL_AWG_LINES turned OFF by going to IDLE (jeff)
- Observatory Mode switched to COMMISSIONING
- H1 ready for PEM team
NOTE: CAL_AWG_LINES Goes Into Error (see attached screenshot [#3])
While getting this measurement going, the guardian CAL_AWG_LINES went into ERROR (node is RED).
(I missed this while setting up measurement and then starting draft of this alog. TJ noticed it when he walked in. I should have noticed it from Verbal or from the notification messages on various Guardian windows.)
Jeff mentions that this can happen after there has been a DAQ Restart (there were atleast two yesterday). To get the node back, Jeff hit the LOAD button on CAL_AWG_LINES.
