DriptaB, FranciscoL

After one week of having the inner beam up on the Rx sensor (alog 78807), on July 2, we moved the beam from up to center.

The last page of EndStationLog.pdf lists the voltage values after each significant step of procedure T2400163. The steps represent writing down a voltage value after a particular change to the beam position. Some highlights from the recorded values:

• ("moved beam") Finalized beam movement of inner beam. See InnerBeamAfter.jpg. Target still on Rx PS. Fine adjustments to yaw had to be done to maximize the signal.
• ("Target off") Recorded the voltage from the Rx sensor with the inner beam only and with the target removed from Rx PS. Readout of FLUKE voltmeter of 1.684V is higher by 6 HOPs to previous position (1.683V).
• ("Both beams") The measurement was recorded after removing beam block on outer beam and removing the target. See BothBeamsAfter.jpg. The measurement of 3.382V is *equal* to the initial measurement (3.382V).

The 'Initial' measurement is *equal* to the last voltage measurement from the previous movement, done on June 25 (alog 78807). The initial and final voltage measurement during today procedure did not change.