Ibrahim

Got the newly cleane BRD mounts (D1900570) for the BBSS and fit-checked them on the suspension. They fit just fine with the only note being that the bottom loop wires (the small ends after the clamp) had to be moved out of the way. Of the 2 I fit-checked, 3 of the 4 holes went in very easily and the other fit mostly easily (no extra force applied going in just was not totally smooth turning in). Pictures attached.

The plan now is to get with Rahul and install the actual BRDs, then re-take the Bounce and Roll mode measurements to confirm that they are damping as expected.