Gerardo M, Mike V, Mark and Randy from Apollo and Mitchell R

Today the ETM-Y Cryo baffle was completed and installed into the tube. The baffle was balanced and ready just before lunch allowing for a post-lunch install. The installation of this baffle was one of the smoothest of the 3 I have been apart of. Great job to all those involved your hard work payed off. The lower copper plate which are part of the Eddy current damper system has yet to be added. These parts had minor modifications done to them and will begin the bake cycle tomorrow. Most tools and hardware has been cleaned up. Final cleanup will take place tomorrow. The teflon pads have been removed from the install fixture allowing it and the balance fixture to be removed from the end station at any time.