(Corey, Doug C., Eric, Jim, Ken, Mike V., Vincent)

Here is an update of work from the last few days.....

BSC#1

After floating both stages last week, work continues here to get the ISI ready for Vincent to test. 

• Clean cabling has been connected and run. 
• Holes were drilled into the Test Stand structure to mount (3) cable feed-thru interface boards. 
• Interface boards have been installed. 
• Vertical GS13's have had dowel pin holes on the base plate reamed out (these holes turned out to be too small for the Dowel Pins which are on the mid-plate of Stage2). 
• (3) Vertical GS13's were installed.

BSC#2

• Doug & Ken reamed out holes on the Stage-2 Top-Facing Optics Table (the machine shop forgot to mill these out for us!  We've had to do this for BSC#1 as well). 
• Small Actuators are practically complete (some of the mounting hardware still needs to be attached)
• Large Actuators are about 60% complete
• Lockers are being built.

Today we hope to get to a point where we can start assembling walls for Stage1 & Stage2 in parallel.