:::  EX is Laser HAZARD  :::  LVEA is Laser SAFE  :::  EY is Laser SAFE  ::

EY:  Travis doing Welding clean-up & possible Quad work (probably most of the day)

Dust:  Dust #9:  Calibrate failure (notified Patrick)

PSL:  Went through PSL Checklist.  Have a "check diode chiller" WARNING & sent an email to the PSL group email.  Doug filled it up around 11:30am

Day's General Activities:

• Before 8am:  Balers continue:  at LVEA, may continue with X-arm
• 8:30-1000:  EX Dressing of ISC cables (Filbertro/Aaron)
• 8:50-9:30:  Jeff/Andres in LVEA looking for stuff
• 10:05:  Joe D (& possibly Chris S & Rick S) working in H2 PSL room on Periscope Assy
• 10:10-10:50:  Andres working on SR Suspension
• 10:15:  Apollo scoping out Nitrogen piping
• 10:20-11:30:  EY RF ISC cabling (Filiberto/Aaron)
• 10:25:  Adjust ADC Channel Numbers feds to HAM4/5 models (Hugo)
• 11:20:  Praxair filling CP6 (MX)
• 1:18 - 1:51:  Call for 100Area Take Cover Drill
• Afternoon:  Apollo removing piping under the H2 Output
• 1:30:  HAM4 work:  connecting/check out sensors, balancing, cable dressing, etc. (Hugh, Mitch)
• 1:45:  Jeff/Andres searching for SUS tooling at LVEA, EX, EY
• 1:58-3:12:  Powering Seismometer (Filiberto)
• 3-4pm:  Rick & Keita searching for beam dump in H1 PSL